Yellow Brick Road
Last updated
Was this helpful?
Last updated
Was this helpful?
In this lab, you will use nested loops to draw a yellow brick road using as little code as possible.
Write a SNAP script to draw a single 20x10 "brick" in the lower left corner of the stage when the green flag is clicked.
Modify your code to draw two bricks side by side. The bricks should share a short edge, like this:
Now modify your code again to build a full row of bricks across the entire length of the stage. Use a loop to keep your code as concise as possible. Remember that the stage is 480 pixels wide.
Now that you can build a row of bricks, add code to build a second row above the first row. The bricks in the second row should share a long edge with those in the first row, but should be "offset" so that the ends of the second row bricks are at the middle of the first row bricks, like this:
Modify your code to build four total rows, alternating back and forth between the "regular" and "offset" rows. Use nested loops to keep your code concise.
Finish off the road the by building alternating rows all the way to the top of the stage. Your final road should look like this:
Lab 2.2 Criteria
1.2 2 bricks bottom left
0.5 points
1.3 row on bottom
0.5 points
2.1 second row offset
0.5 points
3.3 complete road
0.5 points
No extra bricks
0.25 points
Uses at least one loop
0.5 points
Minimum redundancy in all
0.25 points
PROJECT TOTAL
3.0 points
